конфиг wifi на tp-link 1043 под упралением openwrt

[cc lang=txt]

config 'wifi-device' 'radio0'
        option 'type' 'mac80211'
        option 'channel' '5'
        option 'macaddr' '*******************'
        option 'hwmode' '11ng'
        list 'ht_capab' 'SHORT-GI-40'
        list 'ht_capab' 'DSSS_CCK-40'
        option 'disabled' '0'
        option 'txpower' '20'
        option 'htmode' 'HT40+'
        option 'country' '00'
        option 'distance' '12'

config 'wifi-iface'
        option 'device' 'radio0'
        option 'network' 'lan'
        option 'mode' 'ap'
        option 'ssid' '*************'
        option 'encryption' 'psk2'
        option 'key' '***********'

[/cc]

[cc lang=bash]

uci set wireless.radio0.noscan=1
uci commit
reboot

[/cc]

the command “uci wireless.radio0.noscan=1” is actually disabling the scanning capabilities of the wireless driver. Wireless networks interfere to one another with their signal. By default the uci option is set to 0 and the wireless driver is actually scanning for networks around you and if the channels are too occupied it is automatically cutting one of the channels. You must know that in order to use 300 mbps you need 2 channels. Because a channel of 20 mhz can carry only up to 150 mbps so when you put them together you have 40 mhz channel width which can transfer your 300 mbps.

Оставить комментарий